LL-HM01-OFC-HG--SIMTRUM Photonics Store

Sign In

Show Password Forgot your password?

Sign In
Need a new account?
Register

Register

Forgot your password?
Register
Register your account immediately
Sign In

Retrieve password

Get verification code
submission
Sign In

简体中文 English

Products / Lasers/Light /Optical Frequency Comb /Optical Frequency Comb Accessories / LL-HM01-OFC-HG /

Optical Emission Wavelength: 1310/1550 nm ,Optical Receiving Wavelength: 800-1700 nm,High frequency cut-off frequency: 4000MHz (customizable) ,Low frequency cut-off frequency: 500kHz (customizable) ,Frequency Response: 10 MHz-4 GHz (customizable) ,Link Gain: Up to 50 dB

MODEL:LL-HM01-OFC-HG

4-6 Weeks Drawings

Compare

Save To My List

* The prices are indicative only. Please contact us for an official quote. This is single product page, for detail specification please refer to product main page

Compatible

Compare	Model		Drawings & Specs	Availability	Reference Price

Product Specifications

Technical Specifications		Minimum	Typical Value	Maximum
Product Number		LL-HM01-OFC-HG
Supply Voltage		6 V	12 V	15 V
Supply Current			120 mA
Output Optical Power			3 mW
Optical Emission Wavelength			1310/1550 nm
Optical Receiving Wavelength			800-1700 nm
High Frequency Cut-off Frequency (HFC⁾¹			4000 MHz
Low Frequency Cut-off Frequency (LFC)²			500 kHz
Frequency Response	500 kHz- 1.0 GHz		±0.5 dB	±1 dB
	10 MHz- 2.5 GHz		±1.0 dB	±1.5 dB
	10 MHz- 4 GHz		±1.0 dB	±1.5 dB
	50 MHz- 3.0 GHz		±1.0 dB	±1.5 dB
Input/Output Impedance			50 Ohms
Input/Output VSWR^3、4、5（500 kHz- 4 GHz）			1.7：1 dB	2：1 dB
Link Gain^3、4、5	500 kHz- 1.0 GHz			+50 dB
	10 MHz- 2.5 GHz			+50 dB
	10 MHz- 4 GHz			+50 dB
	50 MHz- 3.0 GHz			+50 dB
Bottom Noise⁴@ 1GHz			-134 dBm/Hz
Third Order Intermodulation^5、6@ 1GHz			33 dBm
Full Temperature Gain Change⁷			±2 dB
Isolation⁸		60 dB	80 dB
Operating Temperature		-25~+65 ℃
Storage Temperature		-40~+85 ℃
Supply Voltage		+6 V	+15 V
Maximum Input Optical Power				+10 dBm

¹Typical high frequency cut-off frequency（HFC）is 4000 MHz. For higher HFC products, please contact SIMTRUM.

²Typical low frequency cut-off frequency（LFC）为500 kHz。For lower HFC products, please contact SIMTRUM.

³Measured and specified optical loss budget of 0 dB for 1 m of SMF28 fiber.

⁴0 dB test at gain.

⁵Maximum link gain transmitter and receiver are both two-stage amplifiers. Length dimensions can be further reduced if dual stage amplification is not required.

⁶-40 dBm input power, 0 dBm total output power at 40 dB gain for amplifier tubes on transmitter side (two-tone test)

⁷-25~＋65℃. For other operating temperature ranges, please contact SIMTRUM.

⁸Suitable for the entire frequency band, measurements at 1 GHz.

LL-HM01-OFC-HG - Parameter

LL-HM01-OFC-BB - Parameter

LL-HM01-OFC-FCEO-1560 - Parameter

LL-HM01-OFC-HG - Download

LL-HM01-OFC-BB - Download

LL-HM01-OFC-FCEO-1560 - Download

Company
About us Contact us Worldwide Location
Light Analysis
Spectrometers Hyperspectral Camera Power meters Beam Profiler
Microscope
Confocal Microscope Raman Microscope Microscopy Stages TCSPC Solution
Light Sources
Fiber lasers Fiber Amplifier Diode Lasers Incoherent Light
Imaging
sCMOS Camera SW/MW/LW IR Cameras Infrared Pyrometer Microscope Cameras
Optics
Nonlinear Crystals Thz Components Waveplate Objective Lens

Compare	Model		Drawings & Specs	Availability	Reference Price
		LL-HM01-OFC-BB Optical Emission Wavelength: 1310/1550 nm ,Optical Receiving Wavelength: 800-1700 nm ,High frequency cut-off frequency: 6000MHz (customizable), Low frequency cut-off frequency: 500kHz (customizable) ,Frequency Response: 500 kHz-6.0 GHz (customizable) ,Link Gain: Up to 15 dB		4-6 Weeks	Request for quote
		LL-HM01-OFC-FCEO-1560 Input Pulse Center Wavelength: 1560±10 nm ,Input Pulse Repetition Rate: 100-250 MHz optional ,Input Pulse Energy: ≈2 nJ ,Input Pulse Width: ＜50 fs (120 fs optional) ,Output the signal-to-noise ratio of fceo signal: 25-35 dB, Output RF Interface: SMA ,Input Fiber Type: PM HNLF, Input Fiber Connector: FC/APC		4-6 Weeks	Request for quote